Insulation for Concrete Slab Floors
网上压大小赌博是假的吗celotex pir rigid insulation is the perfect solution for concrete slab floors as no thermal bridging occurs at floor edges.
U-value CalculatorStart your U-value calculation >
in a solid or ground-bearing (because it is continuously supported by the ground across its whole area) concrete floor, the choice of insulation position relative to the concrete slab is commonly linked to the building’s heating system.
网上压大小赌博是假的吗below the slab suits continuous, low level heating, gradually warming the thermal mass of the concrete and sustaining it at a consistent temperature. where the heating is likely to be turned on and off, such as in most new domestic properties, and a faster thermal response is required, the ‘floating floor’ arrangement of insulation above the slab is more appropriate.
网上压大小赌博是假的吗the sub-floor is prepared using well-compacted hardcore and a layer of sand blinding.
- If the insulation is going below the slab, the damp proof membrane (DPM) is laid next, followed by the insulation, a polythene separating layer, and the concrete slab. Depending on the use of the building, the slab can then be finished ready for use, or receive a screed suitable for a floor finish.
- Where insulation is positioned above the slab, the slab and DPM can be installed either way round. The insulation is then laid, followed by a polythene separating layer, and either a concrete screed or tongue and groove chipboard, ready to receive the specified floor finish.
lightweight, rigid polyisocyanurate (pir) foam insulation boards, such as those manufactured by celotex, are among the most thermally efficient, commonly available insulation materials. they keep the depth of the floor construction down, meaning less excavation, and are easily handled and laid to quickly insulate large areas.
for low-rise buildings on poor ground, the floor slab can be designed as a ‘raft’ to act as the foundation. while celotex pir boards have a good compressive strength, they cannot be laid below a raft slab and take the structural load of the building. they can, however, be installed above the raft slab, in the same arrangement as described above. for non-domestic uses you should seek the advice of a structural engineer regarding the suitability of any insulation product in a specific floor system.
Celotex products to consider
1200 x 2400mm
1200 x 2400mm